•   Maintenance of Equipments
•       Laser engraving machine
•       Laser cutting machine
•       Laser marking machine
•       Supporting facility
•   Repairing of Common Failures
•       Laser engraving machine
•       Laser cutting machine
•       Laser marking machine
•   Learning Cente
•   Download of Software

Leaving the work station without notifying supervisor during the working is disallowed to avoid unnecessary loss.

The top lid should be covered on the machine in the process of working to avoid human body injury by deflective laser beam.

Non-professionals are disallowed to disassemble the machine because there are laser parts and HV parts in the machine.

All the parts of the machine should be grounded reliably to avoid human body injury by static.

Since these laser beams are invisible, flammable and explosive materials are forbidden to be placed around the machine to avoid fires caused by deflective laser beam.

Any outlying complete or diffuse reflection mirrors is forbidden to be put in the machine to avoid laser beams cast on human body or flammable materials.

During working, the operator should observe the working condition of the machine all the time (such as: distortion of edge engraving, whether the paper laid on blown up to block the laser beam, abnormal noise, temperature of circulatory water, etc. )

Push or pull of the slipper or the beam with hand is disallowed.

The environment should not be polluted and free of disturbance and influence of strong power, magnetic, and so on.

Turning on of the machine with unstable voltage is forbidden otherwise regulator should be employed.

Operation of the machine by untrained staff is forbidden.

Continuous working time of the machine should not exceed 5 hours (with at least half an hour break during the process)

The water circulation should be clean and its temperature should between 20-30 °C.

Turning on the machine when the ampere meter is at the highest value is forbidden to avoid the laser power supply being breakdown and shortening of the service life of laser diode.

The basic limitation to the use of laser power supply (the highest value of ampere meter should not exceed 20mA)

Cut off the power immediately if malfunction or fire occurs with the machine.

The above should be strictly implemented and followed by users otherwise the manufacturer will shoulder no responsibility to any damage to the machine or injury to human body.